Lylyth, Reckoning of Everblight

My take on Lylyth 3 (minus the base, which I haven’t even started yet – but it’s the same base I used on the Throne)

The mammoth is a GW Thundertusk. There were lots of fun little details to paint, especially when I left most of the gross things from the kit off. As for the wounds, I figure this guy didn’t take very well to being blighted.

Original Miniature

Pictures including base:

3D Printed Pillboxes

I printed up some Warmachine-style terrain on my new 3D printer, one for myself and a few for my local game store.

This one is pretty dark and drab.  Primed with 50/50 Metallic and Black Primer.  Grey parts first covered with cheap craft paint, then tinted with miniature paints.  Printed with PLA on “High” resolution – .12mm layers.

These ones were primed with just Metallic Primer, the grey is a different color of craft paint, and the bottom is red/blue miniature paint.  The red one was printed with PLA at “Hyper” resolution – .05mm layers, and the blue one with ABS at High, but with a thin coat of gap-filling resin over most of it.